Connective Tissue Injury
Tendon/Ligament-to-Bone Tissue Engineering— Current and Emerging Strategies
Lester Smith, PhD and Stavros Thomopoulos, PhD Department of Orthopaedic Surgery, Washington University
Abstract
Connective tissue injuries are a common cause of pain and disability and lead to significant medical costs. These injuries often require reattachment of a soft tissue to bone. The tendon/ligament-to-bone insertion is a functionally graded material that exhibits a gradual transition from soft (i.e. tendon or ligament) to mineralized (i.e. bone) tissue, with no clear borders between tissue regions. The fibrocartilaginous transition region between tendon and bone permits force transmission between two tissues with disparate mechanical properties while mitigating potentially damaging stress concentrations. This transitional region is lost on tendon/ligament injury and is not recreated following surgical repair or natural healing, putting the repair tissue at risk for re-injury and/or chronic pain. The need to recreate a robust transition tissue has led to investigations of tissue-engineered repair strategies. Here, we review current approaches and discuss emerging strategies for tendon/ligament-to-bone tissue engineering.
Keywords Tendon-to-bone, ligament-to-bone, insertion, fibrocartilage, enthesis, gradient, stratified
Disclosure: The authors have no conflicts of interest to declare. Acknowledgments: National Institutes of Health (AR055184) and National Science Foundation (CAREER 844607). Received: April 18, 2011 Accepted: May 20, 2011 Citation: US Musculoskeletal Review, 2011;6(1):11–5 Correspondence: Stavros Thomopoulos, PhD, Washington University, Department of Orthopaedic Surgery, 660 South Euclid, Campus Box 8233, St Louis, MO 63110. E:
ThomopoulosS@wudosis.wustl.edu
Tendon/Ligament-to-bone Insertion Structure and Function
The tendon/ligament-to-bone insertion is a functionally graded material that exhibits a gradual transition from unmineralized (i.e. tendon or ligament) to mineralized (i.e. bone) tissue, with no clear borders between tissue regions.12–14
Tendon/ligament transitions into
fibrocartilage, which transitions into mineralized fibrocartilage, which transitions into bone (see Figure 1). Tendons and ligaments are composed of collagen type I aligned in highly ordered arrays oriented in the direction of force. Fibrocartilage is primarily composed of collagen type II (typically seen in articular cartilage) with significant amounts of collagen type III and small amounts of collagen types I and X, decorin, and aggrecan.2,15
The mineralized fibrocartilage is primarily
composed of collagen type II with large amounts of collagen type X16 and appreciable levels of aggrecan. Mineralized fibrocartilage exhibits less fibril alignment than do fibrocartilage and tendon proper.2
Finally,
Instead of the potentially damaging stress concentrations that would arise at an abrupt interface between a soft tissue and a bone, compositional and organizational gradations through the transitional region mitigate stress concentrations and enable the safe transmission of forces.2
© TOUCH BRIEFINGS 2011
bone is composed of highly mineralized collagen type I matrix. The insertion site therefore exhibits a graded increase in mineralization and a graded decrease in tissue organization from tendon/ligament to bone.2
Current Surgical Approaches Rotator Cuff
The rotator cuff provides stability and motion at the glenohumeral joint.17 Injuries to the rotator cuff can involve one or more tendon tears from the humeral head. The incidence of tears is high; approximately 30% of the population over 60 years of age has a rotator cuff tear.18,19
It is the
Rotator cuff repair to recover shoulder function is one of the most common orthopaedic surgical procedures, with over 75,000 repairs performed each year in the US.20
Healing after rotator cuff
repair is a well-known clinical challenge. Tears occur at or near the tendon-to-bone insertion site, and the goal of rotator cuff repair is anatomic restoration of the tendon attachment.
Surgical repair typically involves securing the tendon to the humeral head with sutures and suture anchors. Although the tendons are effectively re-apposed to their anatomic footprints, the functionally graded transitional tissue found at the uninjured interface is not regenerated. Further complicating the outcome is the common presentation of chronic injuries; this delay often results in tendon retraction22
However, clinical studies have shown failure rates ranging from 30 to 94%.4,21
and osteolysis3 at the insertion site, effectively shortening the
tendon and leaving poor quality bone tissue available for fixation. A recent review of the scaffolds currently used clinically for rotator cuff
11
most common shoulder condition, with more than 17 million individuals in the US affected.18
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68